NFA version 9870
Cisco 1841
NFA shows my Serial0/0/0 interface fine but either doesn't show
or make available all subinterfaces or has some of them as ifindex
values and when I go to the "New" interfaces tab there are
like 50,000 ifindex values. This causes NFA to slow down alot. I
have the snmp persist ifindex so that doesn't change. I ran the
snmpwalk batch file using the parameters in NFA and it works fine,
showing all the correct interfaces. Here's a partial output of
snmp walk. In the interface I see the following available to me. I see
the serial, fa0/0.3, fa0/0.4, ifindex3, ifindex7. That's it.
Plus when I try to look at flows for some of these ifindex values I
get nothing even though they match up to interfaces where I have FNF configured.
Response received:
.1.3.6.1.2.1.2.2.1.1.1: 1
.1.3.6.1.2.1.2.2.1.1.2: 2
.1.3.6.1.2.1.2.2.1.1.3: 3
.1.3.6.1.2.1.2.2.1.1.4: 4
.1.3.6.1.2.1.2.2.1.1.5: 5
.1.3.6.1.2.1.2.2.1.1.6: 6
.1.3.6.1.2.1.2.2.1.1.7: 7
.1.3.6.1.2.1.2.2.1.1.8: 8
Gettting If description values....
Response received:
.1.3.6.1.2.1.2.2.1.2.1: Serial0/0/0
.1.3.6.1.2.1.2.2.1.2.2: FastEthernet0/0
.1.3.6.1.2.1.2.2.1.2.3: FastEthernet0/1
.1.3.6.1.2.1.2.2.1.2.4: Null0
.1.3.6.1.2.1.2.2.1.2.5: FastEthernet0/0.2
.1.3.6.1.2.1.2.2.1.2.6: FastEthernet0/0.3
.1.3.6.1.2.1.2.2.1.2.7: FastEthernet0/0.4
.1.3.6.1.2.1.2.2.1.2.8: FastEthernet0/0.5